Bugs discovered at 1.14 up to the present Stick S3.

[JEONTAEMIN2007]

I will write a bug reporter to improve the bugs I have found out so far.

1. Even when using the custom boot screen (boot.jpg), the boot screen doesn't even appear, and the main screen is immediately displayed (fast boot is turned off).
2. The infrared sensor is not working properly. I don't think the timing for this being captured is right.
3. In the beta version released after version 1.14, badusb does not work.
4. The screen brightness boots to 100%. Even if the setting is 25%, there is a phenomenon where the setting is reset when it actually boots.
5. Sometimes when I go to a specific menu, the back button doesn't work. I can only exit by rebooting.
6. Using the cancel button instead of main Menu in the Evil portal menu causes the device to reboot.
7. When accessing the Karma attack menu, it outputs an error that the device is full of capacity. In reality, the capacity is also quite generous.
8. The interpreter also has problems. The script provided by the formula doesn't work properly, or even if it does, it's forcibly sent to the main menu immediately.
9. In the RFID configuration, the RX and TX settings are incorrectly labeled as G33 and G32. These labels are wrong and should be corrected to G9 and G10 to match the actual hardware
10. This is the same issue with the GPS as noted in item 9. The RX and TX indicators are misleadingly displayed as G32 and G33. They must be updated to G9 and G10 to reflect the correct pin assignment.
11. The screen does not turn off. Even after booting, the screen is always on even when setting it to 10s in the settings.

I am honored for your continued reading of this long article and for your continued efforts to resolve the bugs.

The post has been fixed. I will find the bug again and upload it within a short period.

[LiterallyUser]

3, 8 is firmware wide afaik (affects every device) (3rd one is 100% firmware wide)