Update CrealityPrint_en.po

Author: BriellaBugs

localization/i18n/en/CrealityPrint_en.po

@@ -3042,13 +3042,13 @@ msgid ""
 "to line segments by the firmware."
 msgstr ""
 "Enable this to get a G-code file which has G2 and G3 moves. The fitting "
-"tolerance is same asthe resolution. \n"
+"tolerance is same as the resolution. \n"
 "\n"
 "Note: For klipper machines, this option is recomended to be disabled. "
-"Klipper does not benefit from arccommands as these are split again into line "
-"segments by the firmware. This results in a reduction in surfacequality as "
-"line segments are converted to arcs by the slicer and then back to line "
-"segments by thefirmware."
+"Klipper does not benefit from arc commands as these are split again into "
+"line segments by the firmware. This results in a reduction in surface "
+"quality as line segments are converted to arcs by the slicer and then back "
+"to line segments by the firmware."
 
 # generated by robot
 msgid "Arc tolerance"