Heater bed

[toastquake]

I am having an issue with the stock heater bed actually warming. I have zero errors, I have double checked the pins, config, etc, but it just doesn't warm. Is there something additional that needs to be done to correct this? As far as I can tell this is the last hurdle.

[bean22-dev]

On my machine, the heated bed is connected to the PB0 pin and heats up normally. It's possible that your heated bed heater is faulty.

[toastquake]

Are you using !PB0 like in the sample config? The board layout definitely states it's PB0, I've checked it way too many times, but I absolutely cannot get it to heat. It does heat with the original board without issue. The machine is a K1 Max, for what it's worth. I guess I was just trying to see if maybe the pins needed swapped like on some after market parts.

This is what I am using currently:

[heater_bed]
heater_pin: !PB0
sensor_type: EPCOS 100K B57560G104F
sensor_pin: PC0
max_power: 0.6
min_temp: -100 #0 #zzcatvs
max_temp: 9999999 #120
control: pid
pid_kp: 58.437
pid_ki: 2.347
pid_kd: 363.769

[bean22-dev]

Yes, my machine uses the printer.cfg provided in this repository. The heated bed is connected to the AC-BED, and the jumper cap next to the AC-BED is 5V.

[toastquake]

This is what I've got on the board side

[bean22-dev]

You can join our technical support group: https://discord.gg/yYVx98gCDW