Helper Script Issue

[FaintandFuzzies]

I ran the Helper Script installation and the printer works fine in either fluidd or Mainsail. However, the Guppy screen on the printer is stuck on the Creality default bootup splash screen. I also cannot SSH into root now. It gives me an 'Network Error: Connection Refused' message when I attempt to connect to the printers IP which I know is current because I can actually use the printer.

I think guppy didn't install correctly. I hadn't initially installed it because it was in an unfamiliar menu unlike Kiauh. Once I saw the normal Creality menu's were still present, I SSH'd back into the printer and ran the Helper Scripts again and found the Guppy screen and installed it. It was after that point the screen was stuck on the default boot screen.