problem with klipper

[Proftnt]

I use the K1 SE and this appeared in the error code

{"code": "key92", "msg":"MCU 'mcu' shutdown: ADC out of range
This generally occurs when a heater temperature exceeds
its configured min_temp or max_temp.", "values": []}

[DeeKay-Sigh]

After a few days fiddling with this myself, without further hacking and risking a bricked printer, this appears to be the current path with the software limitations Creality forces. You should have been able to get back to stock firmware, but that error message requires the proper pin call - it's NOT a problem with any sensor or thermistor, as Creality would have you believe, nor is there any issue with the boards that were likely working perfectly fine moments before you attempted this task.

It's an issue with Creality using a virtual setup for stuff like this, so that calls for the pin (such as PA0, in this case) aren't correct, because Creality forces some odd usage such as ADC or something like that, which their software then converts behind their "wrapper" to utilize the correct and expected input info.

Best solution I've decided on, to verify that I'm on the right path with this printer, and whether it will be worth my time to tinker with, is the following: