EthernetESP32 example

[AliReshadF]

Hello

Today I attempted to run HelloServer.ino from the example folder and uploaded this code to my ESP32. Inside the serial monitor, I can see my device obtaining an IP through DHCP and it also prints MDNS responder started successfully. Here is what I got in the serial monitor:

Initialize Ethernet with DHCP:
DHCP assigned IP 192.168.1.102
MDNS responder started
HTTP server started

I can also access the 192.168.1.102 address and see my webpage but when I use software like NETworkManager or AngryIP scanner, I cannot find my device hostname. I would appreciate it if you could help me.

More information :
Development board = DOIT ESP 32 Devkit V1
Arduino core version = 3.0.5

[JAndrassy]

and with the WiFi version of that example you can find the hostname?

[AliReshadF]

and with the WiFi version of that example you can find the hostname?

Yes, I can find it inside of both software. I also should mention I am using enc28j60.

[JAndrassy]

maybe mdns uses WiFi if it is available. is WiFi off?

[AliReshadF]

In my code, there is no code for wifi. I didn't even include wifi libraries. Everything is as same as HelloServer.ino example. Is there any special way to turn off wifi?

[JAndrassy]

esp32 can start the WiFi at boot and connect to the last AP with stored ssid and password.

[AliReshadF]

esp32 can start the WiFi at boot and connect to the last AP with stored ssid and password.

I have checked my router to find out which devices are connected to the router. My esp32 connected via ethernet not wifi. now is there any suggestion?