Hall-Effect Trigger can't be work correctly

[paysagerhapsody]

16-Channel Multiplexers1, (ADC Pin:26)
4-Channel Multiplexers1, (ADC Pin:27)
Select Pin, 22, 23, 24, 25
Analog Smoothing: Enable.
Smoothing Factor: 5
In the web configuration, all the pins can be detected.
When I press a button, its value changes linearly, and this applies to all the buttons as well.
However, when switching to joystick mode, the buttons either trigger falsely or fail to trigger at all, resulting in total chaos.

[TheTrainGoes]

Hi @paysagerhapsody ,

Some more info on this would be useful.

Can you try manually setting each button and then seeing if you can replicate it? Can you also see if its the result of setting all from one button and then getting bad readings off the other multiplexer?