This is a GaN power-transistor adapter board for the KIT_PSC3M5_CC1 evaluation board, featuring a PSOC™ Control C3M5 microcontroller.
Here you may find hardware documents as follows:
- Schematics, PCB layout, and mechanical drawings.
- BOM: Bill of Materials.
- Assembly drawings.
- Rev0 [prototype] hardware files.
- Altium Designer Project.
- Gerber, STEP and PARASOLID files.
- SMath Solver files for OCP blanking time calculation.
- SIMetrix LinearFET simulation files.
- TMR current sensors emulation results.
You may find other documents, such as the user manual, application notes, here: RAK-GaN Documents
-
PSOC™ Control C3M5 (Arm® Cortex®-M33 based) Microcontroller
-
Infineon’s CoolGaNTM Transistors IGB070S10S1XTMA1.
-
Infineon’s OptiMOS™ 5 Linear FET 2 Transistor ISC035N10NM5LF2.
-
High-side TDI gate drivers 1EDN7136UXTSA1.
-
EiceDRIVER™ Gate Driver 1EDL8011XUMA1.
-
TLE5571 TMR Current Sensor.
-
TLE5572 TMR Current Sensors.
-
CANFD transceiver TLE9371VSJXTMA1.
-
RECOM R-78HE5.0-0.3 Power Supply.
-
On-board Debug Probe with USB interface supporting SWD.
-
Isolated J-Link debugger and UART virtual COM port, with USB Type C connector.
-
Isolated I2C headers.
-
Isolated 3.3V LDO.
-
Multiple clock options.
-
120-pin edge connector.
The evaluation board including the software is for testing purposes only and, because it has limited functions and limited resilience, is not suitable for permanent use under real conditions. If the evaluation board is nevertheless used under real conditions, this is done at one’s responsibility; any liability of Rutronik is insofar excluded.
