CodeCampV_Planning_WorkingGroups_Richard

Richard's page

• It is very tedious at present to use the same model on a different data set.

Either - get the "data source" drop down at top of fit page to work to change data Or - change "send to" then "fitting" to instead have "current fit page" or "new fit page" - Now SasView/sasview#863

• Could possibly save results of every fit so that "wind back" to previous results

is possible - but could get very messy for simultaneous fits etc. - Now SasView/sasview#861

Need look at constraints & polydispersity again.

• If possible, would be useful to add a fittable parameter that can be used within

constraints. e.g. I want (Rcore+Tshell)/Rcore = C this requires constraint for Tshell = Rcore(C-1) where C can be fitted. This would save having to write variant models, BUT constraints may need to be called inside polydispersity integrations for say Rcore , which may not be possible here. [FISH does this] - Now SasView/sasview#862