Dual endstops per axis?

[tortfeaser]

Hi, thanks for this design.

I've just pushed the button for an order from JLCPCB then noticed J3 doesn't allow for separate limit switches for separate motors on X and Y axes? Does Grbl allow for this? I was hoping to run this board on a V1 Engineering Lowrider where separate minimum limit switches for each of the two X axis rails to allow for autosquaring (and same on Z min).

Am I talking nonsense? Or does Grbl (unlike Marlin) not allow for two limit switches for each X motor?

[tortfeaser]

Sorry. Just realised this is a dumb question. Two switches are connected and the firmware moves one motor at a time and waits for one of the switches to trigger.