arm64: configs: enable SPI support for Raspberry Pi 5

Enable SPI support for Raspberry Pi 5 (driven by the RP1 chip). This is needed
specially for TPMs connected through the SPI bus.

Signed-off-by: Renê de Souza Pinto <rene@renesp.com.br>

Author: rene

arch/arm64/configs/eve_defconfig

@@ -543,7 +543,6 @@ CONFIG_MHI_BUS_EP=m
 CONFIG_CONNECTOR=y
 CONFIG_ARM_SCMI_PROTOCOL=y
 CONFIG_ARM_SCPI_PROTOCOL=y
-CONFIG_ARM_SDE_INTERFACE=y
 CONFIG_FIRMWARE_MEMMAP=y
 CONFIG_RASPBERRYPI_FIRMWARE=y
 CONFIG_EFI_GENERIC_STUB_INITRD_CMDLINE_LOADER=y
@@ -787,10 +786,12 @@ CONFIG_I2C_RK3X=m
 CONFIG_I2C_SPRD=y
 CONFIG_I2C_TEGRA=y
 CONFIG_SPI=y
-CONFIG_SPI_MEM=y
 CONFIG_SPI_BCM2835=m
 CONFIG_SPI_BCM2835AUX=m
 CONFIG_SPI_BCM_QSPI=m
+CONFIG_SPI_DESIGNWARE=m
+CONFIG_SPI_DW_DMA=y
+CONFIG_SPI_DW_MMIO=m
 CONFIG_SPI_GPIO=m
 CONFIG_SPI_IMX=m
 CONFIG_SPI_FSL_SPI=m
@@ -1069,6 +1070,7 @@ CONFIG_RTC_DRV_IMX_SC=y
 CONFIG_RTC_DRV_XGENE=y
 CONFIG_DMADEVICES=y
 CONFIG_DMA_BCM2835=y
+CONFIG_DW_AXI_DMAC=y
 CONFIG_FSL_EDMA=y
 CONFIG_FSL_QDMA=m
 CONFIG_IMX_SDMA=y