spi: spi-mem: Limit octal DTR constraints to octal DTR situations

[ Upstream commit 8618271 ]

In this helper, any operation with a single DTR cycle (like 1S-1S-8D) is
considered requiring a duplicated command opcode. This is wrong as this
constraint only applies to octal DTR operations (8D-8D-8D).

Narrow the application of this constraint to the concerned bus
interface.

Note: none of the possible XD-XD-XD pattern, with X being one of {1, 2,
4} would benefit from this check either as there is only in octal DTR
mode that a single clock edge would be enough to transmit the full
opcode.

Make sure the constraint of expecting two bytes for the command is
applied to the relevant bus interface.

Reviewed-by: Tudor Ambarus <tudor.ambarus@linaro.org>
Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>
Link: https://patch.msgid.link/20260109-winbond-v6-17-rc1-oddr-v2-3-1fff6a2ddb80@bootlin.com
Signed-off-by: Mark Brown <broonie@kernel.org>
Signed-off-by: Sasha Levin <sashal@kernel.org>
(cherry picked from commit 81bc7d5e78974a60bacd148dbdf7428dc7a2107f)
Signed-off-by: Wentao Guan <guanwentao@uniontech.com>

Author: miquelraynal

drivers/spi/spi-mem.c

@@ -194,8 +194,19 @@ bool spi_mem_default_supports_op(struct spi_mem *mem,
 		if (op->data.swap16 && !spi_mem_controller_is_capable(ctlr, swap16))
 			return false;
 
-		if (op->cmd.nbytes != 2)
-			return false;
+		/* Extra 8D-8D-8D limitations */
+		if (op->cmd.dtr && op->cmd.buswidth == 8) {
+			if (op->cmd.nbytes != 2)
+				return false;
+
+			if ((op->addr.nbytes % 2) ||
+			    (op->dummy.nbytes % 2) ||
+			    (op->data.nbytes % 2)) {
+				dev_err(&ctlr->dev,
+					"Even byte numbers not allowed in octal DTR operations\n");
+				return false;
+			}
+		}
 	} else {
 		if (op->cmd.nbytes != 1)
 			return false;