Follow ttn activation/setup instructions - https://ttn.fyi/activate/

Upload the Arduino IDE Passthrough sketch to enable direct serial access from USB to RN2483A With Passthrough - In Serial Monitor select “Both NL & CR” and “115200 baud” in the bottom right dropdowns and send a command like: mac get deveui

Update the RN2483A firmware v1.0.5 using microchip java utility in Windows If firmware fails then use Module > Add and try again https://www.microchip.com/Developmenttools/ProductDetails/dv164140-1

The RESET switch is inside the case, outside is only the BUTTON switch. Timing is key if upload fails. Upload, then reset near when the COM port request is made. Ensure a USB cable with data (not just power is used).

To find nearby gateways http://ttnmapper.org/

Then use the Console/Data tab from a browser to see received messages/payload https://console.thethingsnetwork.org/applications/

Application > Integrations > MyDevices (Cayenne) https://cayenne.mydevices.com/cayenne/dashboard/

Version History

26/10/19 Initial text.