net: phy: broadcom: Preserve LED4 settings

On CM4/CM5, LED3 is used for ETH_LEDY, while LED4 may be unused or serve
as INT_N. Previously, both LEDs 3 and 4 were mirrored from LED1, which
overwrote the INT_N configuration on CM5.

Fix this by only shadowing LED1 to LED3, preserving the setting for
LED4/INT.

Fixes: 9704fab ("net: phy: broadcom: Allow ethernet LED mode to be set via device tree")
Signed-off-by: Nicolai Buchwitz <nb@tipi-net.de>

Author: nbuchwitz

drivers/net/phy/broadcom.c

@@ -516,10 +516,14 @@ static int bcm54xx_config_init(struct phy_device *phydev)
 			BCM54XX_SHD_LEDS1_LED3(BCM_LED_SRC_MULTICOLOR1);
 		bcm_phy_write_shadow(phydev, BCM54XX_SHD_LEDS1, val);
 		/* BCM54210PE controls two extra LEDs with the next register.
-		 * Make them shadow the first pair of LEDs - useful on CM4 which
-		 * uses LED3 for ETH_LEDY instead of LED1.
+		 * Make LED3 shadow LED1, but preserve LED4 as is - useful on
+		 * CM4/CM5 which use LED3 for ETH_LEDY instead of LED1. LED4
+		 * is either unused or configured as INT pin on CM5.
 		 */
-		bcm_phy_write_shadow(phydev, BCM54XX_SHD_LEDS1 + 1, val);
+		reg = bcm_phy_read_shadow(phydev, BCM54XX_SHD_LEDS2);
+		reg &= ~(0xf << 0);
+		reg |= BCM54XX_SHD_LEDS1_LED1(BCM_LED_SRC_MULTICOLOR1);
+		bcm_phy_write_shadow(phydev, BCM54XX_SHD_LEDS2, reg);
 
 		val = BCM_LED_MULTICOLOR_IN_PHASE |
 			BCM54XX_SHD_LEDS1_LED1(led_modes[0]) |