I have successfully use this using the block/js plus serial output. Thanks. It is a great learning environment.
Is it possible to compile this with my own code for BLE under yt / mbed environment?
TL;DR:
As a more mature project I would like to move to BLE, instead of moving to another weather board.
But the initial part found it is hard as not sure what is going on. I suspect it might be due to some device limitation (memory etc. got some error code over the bitcode led). I wonder whether I can escape this student mode to more familiar mode of c++. And wonder whether any chance of debug over this environment especially how to check on any memory issue.
But before I ticket this possibility to tickle the limit of the mix of ble + weather:bit, I wonder any chance to do this at all. (I note another module using ble and cpp cannot be run even for some xmas LED / song also encounter problem with the new BLE memory. Wonder. May be only serial not radio/ble ...
I have successfully use this using the block/js plus serial output. Thanks. It is a great learning environment.
Is it possible to compile this with my own code for BLE under yt / mbed environment?
TL;DR:
As a more mature project I would like to move to BLE, instead of moving to another weather board.
But the initial part found it is hard as not sure what is going on. I suspect it might be due to some device limitation (memory etc. got some error code over the bitcode led). I wonder whether I can escape this student mode to more familiar mode of c++. And wonder whether any chance of debug over this environment especially how to check on any memory issue.
But before I ticket this possibility to tickle the limit of the mix of ble + weather:bit, I wonder any chance to do this at all. (I note another module using ble and cpp cannot be run even for some xmas LED / song also encounter problem with the new BLE memory. Wonder. May be only serial not radio/ble ...