Warning symbol from Fusion 360

[dkag123]

Hi All,
I do not have the fusion plugin installed, maybe this is why.. but just in case its something else..
I tried 2 exports from fusion and both have this warning sign and then a blank line of code.
"G28 G91 Z0"
Does anyone know what is going on?
Thanks!

[breiler]

This warns you about a very common issue for beginners. If you haven't set the G28 position and run this gcode it will move it to the default G28 Z0 which often makes the machine crash. If you've configured G28-position with G28.1, you can ignore this warning. There is an option in Fusion to disable generating this command.

[dkag123]

Thanks for that, I did eventually figure it out but I wish I would have seen your reply earlier..